harvest right - Uma visão geral
harvest right - Uma visão geral
Blog Article
Indoor Farmer exists to offer Canadian’s the opportunity to "grow their own" food and medicine. Over the years we have added a large selection of outdoor gardening products to compliment our indoor growing collection.
4) I made a plastic shield to protect the main circuit board of the FDer. it simply slides into place and protects the top and both sides of the board from condensation.
Suitable placement of food around the freeze drying trays is much more than simply an aesthetic option—it’s a science. Making sure an excellent distribution, without the need of overpacking, is essential for reaching a dependable freeze drying end result.
Truth be told, there isn’t much of a difference in terms of interface, but the Pharmaceutical models do offer a bit more customization in terms of settings. The Home Pro models however get the job done just as well and have bigger capacity for the money.
And once you have resolved your issue I hope you will stay around and talk to us all about what you have been drying in your machine, etc.
Odds are the problem is the vacuum hose or its end connections, the drain valve, or the door gasket. Based upon my experience I'd double check the fittings while installed on the FDer.
I did wonder though, since this is gravity flow and not pressure driven as on a car, if having the filter mounted horizontally might result in using only "half" the filter, as the oil would tend to travel through the low side of the filter -- although in practice, I suppose, as the filter material gets plugged it would force the fluid level higher.
So I corrected the oversight - I drilled and tapped the elbow to add the port. Here is more info a picture. It worked great today when I flushed the pump to clear out the gunk.
Drying things out played a roll as well as the added insulation. We had 3.5 weeks of constant rain here in central NC with humidity over 95% and temps near 95F in the beginning and tapering down to 80F by the end of the rain. The condensation on the front panel around the seal had water running down the front of the Freeze Dryer constantly during the entire cycle, not just the freeze cycle. I initially went into the FDer to simply stop the humdity from reaching the outer chamber shell and freezing.
adding insulation on the 3 ports on the chamber (One time thing - the drain and vacuum ports are very easy to get to)
Posted January 21, 2016 (edited) On 12/1/2015 at 0:16 PM, Jenipher said: Tony, if you see this, I went ahead and purchased the catch can. Do you think it's okay to just purchase a reducer to go from the size of more info the exhaust to the size of the hose that came with the can? Hopefully I said that in a way that makes sense! As well, does it matter which port is used as "in" and which as "out"? Thanks so much, Jen Hi Jen, Sorry to be gone so long. I did exactly as you proposed. I purchased a brass reducer and pushed the blue hose over it.
Shortly after getting the freeze dryer, Lance's wife began shipping over boxes of dehydrated food. We get the food, rehydrate it, and make some incredible meals. My favorite was the pizza Lance would whip up!
Back from our trip I turned the unit on and to my dismay found that the display was missing the middle two lines.
I started by removing the 3 grocery bags that were holding the 2 thick bags that had at one time held the berries. Struck by how much it looked like a placenta - bag and all!